Pacific Northwest Four Wheel Drive Association

Pacific Northwest Four Wheel Drive Association (http://www.pnw4wda.org/forums/index.php)
-   TJ's (http://www.pnw4wda.org/forums/forumdisplay.php?f=36)
-   -   Reiter Pit 2007 (http://www.pnw4wda.org/forums/showthread.php?t=99)

Jon KB 01-07-2009 07:07 PM

Jon K-B's Rig
 
Evans Creek 2006
1997 TJ new to me stock
http://i218.photobucket.com/albums/c...P1010034-2.jpg
Reiter pit 2007
4" lift 1" body ,33" tires, Modified front bumper, added Winch, home built On-Board Air,
http://i218.photobucket.com/albums/c.../P1010068B.jpg
Liberty 2008
Added home built Rocker Guards/Sliders,Tom Woods Axle and super shorty SYE kit, Home built tire swing carrier
http://i218.photobucket.com/albums/c...8/P6130068.jpg
http://i218.photobucket.com/albums/c...8/P6130069.jpg

Jon K-B
Cascade 4X4's

Ceg_ 01-07-2009 09:30 PM

Nice mods so far.

wood 01-12-2009 11:17 AM

Good looking jeep, what are you running for on board air? Is it a A/C mod?

Jon KB 01-12-2009 03:54 PM

Oba
 
Quote:

Originally Posted by wood (Post 553)
Good looking jeep, what are you running for on board air? Is it a A/C mod?

Yes it's a A/C mod.
I'm using a York A/C unit from a Volvo, all parts were self-fabbed or scrounged with the exception of the serpentine belt pulley wheel and the oil/air separator.

Works very well although I will add a under-hood manual throttle lock to allow increase the idle while airing up. Currently it takes 1 -2 minutes per tire.

I have also collected sime low volume air-tools that can run off of it.

ReedJeep 03-29-2011 11:00 PM

Hey Jon, nice jeep. I am currently working on a self York 210 a/c mod myself for an 05 4.0 w a/c.
I figured I could fab the bracket with a little welding time. However I am almost half way to spending as much as I should have to buy the dumb expensive Kilby system.
Could you give me some incite on how you made your bracket. I have the plate and holes down pretty good. I think it is the positioning of the alt bracket on the bottom. I am not leaving either enough room for the idle tension or something because I cant get the belt to clear. Pix would be great or some helpful hints.
Thanks for any help or advice.


All times are GMT -7. The time now is 06:21 AM.

Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.