View Single Post
Old 01-02-2010, 08:34 PM
warrpath4x4 warrpath4x4 is offline
Join Date: Feb 2009
Location: 97838
Posts: 143

new engine still wrapped up till i get the sheetmetal all cleaned up and ready to put on.

here you can see how flat the old springs were

and with the helper spring

not sure why all these holes were drilled in the frame but i am going to weld them up

got my BFG's mounted on a different set of wheels with less back spacing, mounted them on the truck and without the engine in its almost level on the bed.

got the old heater core out, didnt come out as simple as i had planned, im going to weld in a piece of sheetmetal to fill the hole. then i have a summit brand mojeve heater to mount inside.

it sits at 23 3/4" t the pinch seam.

North East Oregon 4 Wheelers, PR officer

MEMBER OF: blue ribbon coalition, tread lightly,
Reply With Quote