View Single Post
Old 03-07-2010, 07:34 PM
warrpath4x4 warrpath4x4 is offline
Join Date: Feb 2009
Location: 97838
Posts: 143

cleaned the frame up some with a wire wheel

threw some black spray paint down

for now i welded the holes up that were drilled in the WARN winch bumper and threw some spray paint on it also. the jack stand is there because i need the right bolts for it, i just put a couple smaller ones in to hold it. after its all up and running i am going to build a bumper for it.

i also trimmed the fenders and found some bondo in the driver side fender. heres a comaprison from the uncut driver side to the cut passenger one, i need to clean up the cuts these are just rough cut out with the plasma.


North East Oregon 4 Wheelers, PR officer

MEMBER OF: blue ribbon coalition, tread lightly,
Reply With Quote