Thread: my 97 XJ
View Single Post
Old 12-11-2010, 05:41 PM
warrpath4x4 warrpath4x4 is offline
Join Date: Feb 2009
Location: 97838
Posts: 143

ive been working on this for a while in my spare time, building rock rings.

started out with a piece of backing board and made a template

test fitting the template and did some trimming and made the one hole bigger where the valve stem is

rough cut

cleaned it up and beveled the edges

cleaned the edge of the wheel

heres a test weld after tacking

welded in

cleaned up and painted

now i just have to do 3 more and install my inner airlocks, then wrap the 35's around them. dont worry i am going to replace the valve stem.

North East Oregon 4 Wheelers, PR officer

MEMBER OF: blue ribbon coalition, tread lightly,
Reply With Quote