Thread: Doodoob's 03
View Single Post
  #2  
Old 07-16-2011, 09:51 PM
Doodoob's Avatar
Doodoob Doodoob is offline
Friends
 
Join Date: Jul 2011
Location: Soon to be WA
Posts: 12
Default

Once all the cutting and painting is done there you have to put the corners up and clamp them in place. Once clamped you have to mark your new opening and bolt holes.



Once the corners are installed you have to center the flares and weld them in place.



I also used one of the bolt holes to secure the flare/corner to the rocker as well as a tab.


The rockers are fairly straight forward. You just raise them up with a jack, mark the holes once it is in the proper position, lower them drill the holes, install the rivnuts where needed, bolt them on.

Reply With Quote