Thread: Doodoob's 03
View Single Post
  #3  
Old 07-16-2011, 09:52 PM
Doodoob's Avatar
Doodoob Doodoob is offline
Friends
 
Join Date: Jul 2011
Location: Soon to be WA
Posts: 12
Default

Be careful, I had a bolt break while installing one of the rivnuts and it scratched the paint pretty good.

Once the rockers are bolted in you have to remove the corners, weld the flares all the way, and paint them, then reinstall.
Now its time to move onto the gas tank. The following pick is the space behind the diff to the Kilby skid.

When removing be careful so this doesn’t happen.

I had to use some high strength epoxy on this.
GenRight changed design again on the tanks. I highly reccomend you wait to put the spacer in until the rear CO mounts are installed.


Spacer installed.

Cut the exhaust.

Raise the tank once you swaaped the lines and pump over.


Reply With Quote