Thread: Doodoob's 03
View Single Post
  #6  
Old 07-16-2011, 10:55 PM
Doodoob's Avatar
Doodoob Doodoob is offline
Friends
 
Join Date: Jul 2011
Location: Soon to be WA
Posts: 12
Default

Moving on to the front axle. Once you put the CA mounts on the frame, we put the axle on stands under the jeep, set the ride height, pinion/castor, connected the steering, and started measuring for control arms. Cut, weld, and bolt on the lowers.



There is a Johnny joint that you use for the stock axle.

You need to fab the front upper and bolt it in. Then you must tack in the track bar mounts and fab up the track bar.



Now its time to cycle the suspension. Once you are sure it all clears its time to start on the front CO mounts.
For me I used my marks for the plum bob to start with. I then got the feet mounts in position and tacked them in place. We then eyeballed the inner fender and drew a pattern to cut out.

Reply With Quote